Tech Talk Blog

The dynamics of wetting are described below:

Spreading = A – ( B+ C )

Where:

• A = surface energy of solid (given below)
• B = surface tension of liquid
• C = surface energy of solid-liquid interface

If Spreading is:

• Negative. Then, liquid will bead up.
• Zero. Then, liquid will spread.
• Positive. Then, liquid will spread.

If the material surface energy is relatively low, then the coating will not flow well and fisheyes, pinholes, gaps, or air bubbles will form. If the material surface energy is too high, then the paint, ink, or coating may bleed or be difficult to control. Therefore, the surface tension of the liquid and the surface energy of the material must be matched for the application.

Don’t just listen though – take a look! Visit our Video Learning Center for an in-depth look.

Using simple plasma surface modification techniques, we are able to manipulate the surface of most plastic devices to contain fluids or direct flow.

Surface treatment zone

the surface treatment zone shown in the picture above is 0.9mm. The wet zones are hydrophilic drawing water into the narrow zone while the other areas are hydrophobic to the natural polystyrene material.

If you would like more information about this process, please vist our website.