Tech Talk Blog

Did you realize there are probably over 300 types of Rulon? Rulon is a self-lubricating material that can almost be considered “generic” in some ways.  It is a PTFE material with various fillers; it is the type and amount of filler that makes each variation of Rulon unique.

When choosing Rulon, we ask:

1) What is the application function – bearing? Seal? Gasket? Some materials can be used for all applications.

2)  What is the temperature? -400 to +550 is the general range Rulon can accept. For design purposes, we need to know how much press fit and close in to account for in the gradient.

3)  What is the environment? Some types are made for FDA or USDA environments or for resisting abrasion. Most PTFE materials don’t do well in water, but a few do.

4)  What is the speed? All types of Rulon can take 400/500 feet per minute without lubrication; but we need the load to be a bit more accurate. Rotating? Oscillating? Linear?

5)  What are the loads on that bearing? Most can handle 1000 psi, but others can withstand higher levels.

6)  What type of hardware (consider temperature)? Only a few types of Rulon can work with stainless steel.

7)  What is the surface finish? 8-16 rms on the shaft is recommended, but for holding purposes, we would suggest 32 rms.

We can help you choose the right Rulon for your application.

Molecular weight and crystallinity are two factors in PTFE that determine many of it’s performance qualities. Both of these properties are highly dependant on the sintering operation of the PTFE production. If the material is cooked (sintered) too long or at too high a temperature it can degrade the polymer. Molecular weight is a measure of the polymer chain length and it affects flex life, tensile strength and elongation. As molecular weight increases so do these properties and paying attention to gel temperatures and dwell times during sintering is extra critical.

Crystallinity of PTFE can vary considerably depending on processing. This value can be seen in small variations in the specific gravity although in practice most PTFE materials fall in the 50-60 percent crystalline percentage. Increasing crystallinity decreases flex life, increases compressive stress and decreases recovery values, permeability and wear life. Other properties of PTFE, such as thermal, chemical, electrical and friction, are not generally affected by crystallinity changes.

So, sintering and other processing steps do a make a difference in deterimining the quality of PTFE. If you need to maximize the performance of your PTFE parts, including Rulon, Fluorosint, Ultraflon or even generic products, be sure you contact Tri Star Plastics first.  We can help you select the right material and the right process.

Rulon bearing materials, and other filled PTFE materials like Fluorosint and Ultraflon, have a unique reaction where coefficient of friction is concerned. Unlike most materials which theorize that higher loads and speeds mean higher friction, filled PTFE products are just the opposite. WIth these materials, the higher the load – the lower the friction. Same goes for speed as a general rule. Design your PTFE bearings with the thought in mind that surface contact area can be reduced dramatically to optimize friction properties. Remember, more is not necessarily better when it comes to PTFE based bearing materials.

Still have questions? Don’t hesitate! Ask The Experts!

Rulon is a family of PTFE based materials used in bearing and seal applications. Most Rulon materials will operate in temperatures from -400 to +550F in virtually all chemical environments. There are now Rulon materials with FDA clearance and USPVI use. Most frequently used Rulon’s are Rulon LR, Rulon J, Rulon 641 and Rulon 142. Visit www.tstar.com for more information and design assistance.